Table of Contents
Advertisement
Installing QSFP+ transceivers
32
RackSwitch G8264T: Installation Guide
The RackSwitch G8264T supports QSFP+ fiber transceivers. For the available
transceivers for the switch, see
configurator/americas/bhui/launchNI.wss.
The QSFP+ ports accept approved QSFP+ transceivers. The QSFP+ optical
transceiver provides an MTP cable connector for connecting to external ports.
CAUTION:
This product might contain one or more of the following devices: CD-ROM
drive, DVD-ROM drive, DVD-RAM drive, or laser module, which are Class 1
laser products. Note the following information:
•
Do not remove the covers. Removing the covers of the laser product could
result in exposure to hazardous laser radiation. There are no serviceable
parts inside the device.
•
Use of the controls or adjustments or performance of procedures other
than those specified herein might result in hazardous radiation exposure.
(C026)
CAUTION:
This product contains a Class 1M laser. Do not view directly with optical
instruments. (C028)
To install a QSFP+ optical transceiver in a QSFP+ port, complete the following
steps.
Note: To avoid damage to the cable or the QSFP+ transceiver, do not connect the
cable before you install the transceiver.
1. Remove the safety cap and pull the locking lever into the down (unlocked)
position.
2. Insert the transceiver into the port until it clicks into place. Use minimal pressure
when you insert the transceiver into the slot. Do not use excessive force when
you insert the transceiver; you can damage the transceiver or the QSFP+ slot.
The transceiver has a mechanical guide key to prevent you from inserting the
transceiver incorrectly.
3. Pull up the locking lever to lock the transceiver into place.
4. Connect the fiber-optic cable.
To remove a QSFP+ optical transceiver, disconnect the fiber-optic cable, and
pull down the locking lever to release the transceiver. After you remove the
transceiver, replace the safety cap.
https://www-01.ibm.com/products/hardware/
Advertisement
Table of Contents
