Service Tools - Daikin R410As Service Manual

Si39-302
1.3

Service Tools

R410A is used under higher working pressure, compared to previous refrigerants (R22,R407C).
Furthermore, the refrigerating machine oil has been changed from Suniso oil to Ether oil, and if
oil mixing is occurred, sludge results in the refrigerants and causes other problems. Therefore,
gauge manifolds and charge hoses that are used with a previous refrigerant (R22,R407C) can
not be used for products that use new refrigerants.
Be sure to use dedicated tools and devices.
!
Gauge manifold
Charge hose
Charging cylinder
Gas detector
Vacuum pump
(pump with reverse flow
preventive function)
Weighting instrument
Charge mouthpiece
Flaring tool (Clutch type)
Torque wrench
Pipe cutter
Pipe expander
Pipe bender
Pipe assembling oil
Refrigerant recovery
device
Refrigerant piping
!
* O: Soft (Annealed)
Precautions for New Refrigerant (R410)
Tool compatibility
Tool
R410A
Check your recovery device.
As for the charge mouthpiece and packing, 1/2UNF20 is necessary for mouthpiece size of
charge hose.
Copper tube material and thickness
Pipe size
Material
φ6.4
φ9.5
φ12.7
φ15.9
φ19.1
φ22.2
1/2H
φ25.4
1/2H
φ28.6
1/2H
φ31.8
1/2H
φ38.1
1/2H
φ44.5
1/2H
H: Hard (Drawn)
Compatibility
HFC HCFC
R407C R22
✕
✕
"
✕
"
"
"
✕
"
"
"
"
"
✕
See the chart below.
Ve-up
R407C
Thickness
tmm
O 0.8
O 0.8
O 0.8
O 1.0
O 1.0
1.0
1.0
1.0
1.2
1.4
1.6
Precautions for New Refrigerant (R410)
Reasons for change
2Do not use the same tools for R22 and
R410A.
2Thread specification differs for R410A
and R407C.
2Weighting instrument used for HFCs.
2The same tool can be used for HFCs.
2To use existing pump for HFCs,
vacuum pump adaptor must be
installed.
2Seal material is different between R22
and HFCs.
2Thread specification is different
between R410A and others.
2For R410A, flare gauge is necessary.
2Torque-up for 1/2 and 5/8
2Due to refrigerating machine oil
change. (No Suniso oil can be used.)
2Only φ19.1 is changed to 1/2H material
while the previous material is "O".
Ve-up
11
R410A
Material
O
O
O
O
1/2H
1/2H
1/2H
1/2H
1/2H
1/2H
1/2H
Thickness
tmm
0.8
0.8
0.8
1.0
1.0
1.0
1.0
1.0
1.1
1.4
1.6
289