Connections And Terminal Designation - Siemens SITOP Manual

Description, device design, dimension drawing

2.2 Connections and terminal designation

2.2 Connections and terminal designation
The input terminals
0 V connection
connect to the loads to be supplied (also see Chapter Installation (Page 43)).
The operating status of the device can be processed using the group signal contact or status
output
(SITOP select and SITOP PSE200U) (Page 15)).
The remote reset input
(function, see Chapter Status displays and signaling (Page 15)).
Connections and terminal designations for 6EP1961-2BA00
①
②
③
④
Connections and terminal designations for 6EP1961-2BA11, 6EP1961-2BA21 and 6EP1961-2BA51
①
②
③
④
reset (RST)
Connections and terminal designations for 6EP1961-2BA31, 6EP1961-2BA41 and 6EP1961-2BA61
①
②
③
④
④
12
①
can be used to establish the connection to the supply voltage. The
②
is used to supply the internal electronics. Output terminals
④
(function and contact rating, see Figure 2-4 Operating displays and signaling
④
is used to reset outputs that have been automatically switched off
+ 24 V input
0 V connection
+ 24 V output: 1, 2, 3, 4
group signal contact (13, 14)
+ 24 V input
0 V connection
+ 24 V output: 1, 2, 3, 4
group signal contact (11, 12, 14); remote
+ 24 V input
0 V connection
+ 24 V output: 1, 2, 3, 4
not assigned (NC)
status output (S); remote reset (RST)
2 screw terminals
2 screw terminals
One screw terminal each
One screw terminal each
2 screw terminals
2 screw terminals
One screw terminal each
One screw terminal each
2 screw terminals
2 screw terminals
One screw terminal each
2 screw terminals
One screw terminal each
Manual, 01.2017, C98130-A7579-A1-2-7629
③
are used to
Selectivity modules