Two Treatment Modes: Stamp & Flash And Slide & Flash - Philips Lumea SC2009 User Manual

3 Press the device firmly onto your skin to ensure proper skin contact.
The 'ready to flash' light on the back of the device lights up green to
indicate that you can proceed with the treatment.
4 Press the flash button to release a flash. You should feel a warm
sensation because of the flash.
Note: The light produced by the device is harmless to your eyes. It is not
necessary to wear goggles during use. Use the device in a well-lit
room so that the light is less glaring to your eyes.
5 Place the device on the next area to be treated. After each flash, it takes
up to 3.5 seconds until the device is ready to flash again. You can release
a flash when the 'ready to flash' light lights up again.
6 To make sure that you have treated all areas, release the flashes close to
each other. However, make sure you flash the same area only once.
Flashing the same area twice doesn't improve the effectiveness of the
treatment, but increases the risk of skin reactions.
Two treatment modes: Stamp & Flash and Slide & Flash
Your Philips Lumea has two treatment modes for more convenient use on
different body areas:
- The Stamp & Flash mode is ideal to treat small or curvy areas like knees
and underarms. Simply press and release the flash button to release a
single flash.
- The Slide & Flash mode offers convenient use on larger areas like legs.
Keep the flash button pressed while you slide the device over your
skin to release several flashes in a row.
19
English