Snmp - Siemens HiPath 2000 Administration Manual

Administration via Local Phone
|
--- Admin
|
--- Network
|
--- Update Service (DLS)
|--- DLS address
|--- DLS port
|--- Contact gap
|
--- Secured
3.3.8

SNMP

The Simple Network Management Protocol is used by network management systems for mon-
itoring network-attached devices for conditions that warrant administrative attention. An SNMP
manager surveys and, if needed, configures several SNMP elements, e.g. VoIP phones.
The OpenStage 60/80 supports SNMP version 1 and 2.
Data required
• Trap sending enabled / Traps enabled: Enables or disables the sending of a TRAP mes-
sage to the SNMP manager.
Value range: "Yes", "No".
Default: "No".
• Trap destination / Manager address: IP address or hostname of the SNMP manager that
receives traps.
• Trap destination port / Manager port: Port on which the SNMP manager is receiving
TRAP messages.
Default: 162.
• Trap community / Community password: SNMP community string for the SNMP man-
ager receiving TRAP messages.
• Queries allowed: Enables or disables queries from the SNMP manager.
Value range: "Yes", "No".
Default: "No".
• Query password: Password for the execution of a query by the SNMP manager.
• Diagnostic sending enabled: Enables or disables the sending of diagnostic data to the
SNMP manager.
Value range: "Yes", "No".
Default: "No".
• Diagnostic destination: IP address or hostname of the SNMP manager receiving diag-
nostic data.
• Diagnostic destination port: Port on which the SNMP manager is receiving diagnostic
data.
A31003-S2010-M100-10-7619, 27/08/2008
HiPath 2000/3000/5000 - OpenStage Family, Administration Manual
administration.fm
Administration
IP Network Parameters
3-21