EXTEND YOUR WiFi COVERAGE (MESH):
Preparation: Connecting the new Air 4920
In the room in which the router is located, position the new Air 4920 at a distance of around three
meters from the existing Air 4920 device, connect it in to the mains and wait until both 5 GHz
and 2.4 GHz LEDs are flashing green ( 4 seconds ON, 4 seconds OFF ). This may take up
to 3 minutes.
Press the WPS button (
then on the new Air 4920 for 2 seconds (2.b).
The 5 GHz and 2.4 GHz LEDs (
This process may take up to five minutes. The connection has been established once the ( )
LEDs light up green (The 5 GHz LED will turn OFF briefly once in every 5 seconds).
Congratulations, you have successfully configured your new device. Your existing
Air 4920 network credentials are automatically configured to your new Air 4920.
If the 5GHz LED on the new device does not light up green within five minutes,
please repeat step 2.
Setting up the Air 4920 in the room of your choice
The new Air 4920 can now be unplugged and placed in the room of your choice.
The connection will be established automatically. This process will take up to three minutes.
If 5 GHz LED does not light up green (The 5 GHz LED will turn OFF briefly once in every
5 seconds) within three minutes, please consult the chapter «Troubleshooting» (page 5).
(Optional) Now, you can connect wired devices (in this example, the Set-Top Box) to the Air 4920
using the ethernet cable (yellow plug).
) on the existing Air 4920 (next to the router) for 2 seconds and
) start to flash and the devices connect automatically.