RCA ANT752 User Manual page 2

Step 4: Attach the front section to the rear section
Step 5: Attach the mast clamp U-bolt
Step 6: Install the transformer and your coaxial
cable (not included)
Attach the antenna's front section to the rear
section by sliding the tapered end of the front
section into the end of the rear section. The
threaded studs on both sections of the antenna
should be facing down
Align the holes and attach the included VHF
element to the top of the boom. Then secure
with provided bolt and nut.
Align the 2 phasing lines from the front
section of the antenna onto the threaded studs
on the rear section and secure with 10/32" hex
nuts.
Insert the U-bolt into the mast clamp on the
antenna and loosely thread the 1/4" hex nuts
onto the U-bolt.
Do not tighten the hex nuts yet!
Attach the transformer to your coaxial cable (not
included).
Find the 10/32" hex nuts and washers in the hardware
bag. Use them to attach the transformer to the bottom
of the antenna at the UHF element studs on the front
section.
Make sure to place the leads of the matching
transformer between the two washers on each post as
shown here.
Finally, tighten the hex nuts to secure the leads.