Configuring The Positioning Axis/Synchronous Axis Technology Object; Configuration - Basic Parameters - Siemens SIMATIC S7-1500 Function Manual
Update 3
Hide thumbs
Also See for SIMATIC S7-1500:
- System manual (393 pages) ,
- Function manual (362 pages) ,
- Manual (188 pages)
Table of Contents
Advertisement
Configuring
6.6 Configuring the positioning axis/synchronous axis technology object
6.6
Configuring the positioning axis/synchronous axis technology object
6.6.1
Configuration - Basic Parameters
Axis name
Define the name of the positioning axis/synchronous axis in this field. The technology object
is listed in the project navigation under this name. The variables of the technology object can
be used in the user program under this name.
Axis type
In this selection, configure whether the axis should perform linear or rotary motions.
Units of measure
In the drop-down list, select the desired measurement system for the position and velocity of
the axis.
Modulo
Select the check box "Enable modulo", if you want to employ a recurring unit of measure for
the axis (e.g. 0-360° for an axis of the "rotary" axis type).
● Modulo start value
In this field, define the position at which the modulo range should begin (e.g. 0° for an
axis of the "rotary" axis type).
● Modulo length
110
In this field, define the length of the modulo range (e.g. 360° for an axis of the "rotary"
axis type).
S7-1500 Motion Control V13 Update 3
Function Manual, 07/2014, A5E03879256-AC
Advertisement
Table of Contents
