Quiksilver DEEP X System User Manual page 30

CHRONO APP
The chronograph in your Deep X is the stop watch, it will help you to track your work out performances by
analyzing and storing your results (lap chrono, total, best lap)
1.0 Chronograph
In CHRONOGRAPH mode press SET to start the chronograph.
The lap/split time display begins with 1/100 seconds, then
seconds, then minutes. Press SET to stop the stopwatch. You
can press the SET key to resume the stopwatch. While the
stopwatch is running, press (+) to set a lap.
1.1 Chronograph Info
The SAVE and RESET menu items are only visible when the
Chrono is at Stop state. Once the chronograph is stopped,
press (+) key and select SAVE to store your run info into the
watch memory. Press again (+) key to go back into the chro-
nograph menu and select VIEW LOG. Select the correct RUN
# and press SET to go through the data lap by lap. After going
through the lap time of each lap, it will display the total time
and the best lap time.
28
1.2 Delete Logs
You can either delete log by log or delete all logs at once. To
delete a specific log, go into stopwatch menu and select DE-
LETE LOG. Then select the run # you want to delete and press
SET. To delete all logs, select DELETE ALL and press SET. A
YES/NO prompt will appear, select YES if ok.
1.3 Power-On Defaults
Total Time Value - 00hr, 00min, 00sec (reset state)
Lap Time Value - 00hr, 00min, 00sec (reset state)
Lap Count - 0
1.4 Boundary Conditions
Hour - 0 to 99
Minute - 0 to 59
Second - 0 to 59
Millisecond - 00 to 99
No of Laps - 0 to 99
No of Runs - 0 to 99