Download Print this page

Connect The Cables To The Base - JVC TK-C205VP Instructions Manual

Hide thumbs Also See for TK-C205VP:

Advertisement

Available languages

Available languages

Installation and connection

Connect the Cables to the Base

Connect the coaxial cables and power supply cable to the terminals within the Base.
• Turn OFF the power supply to all compornents before making connections.
Fold back the net and insulate so that a short cir-
cuit does not occur from the net coming apart.
Net
12mm
15
/
"
(
)
32
CAUTION:
• If thin cables are used (i.e. with a high
resistance), a significant voltage drop
will occur when the unit is at its
maximum power consumption. Either
use a thick cable to restrict the voltage
drop at the camera side to below 10%,
or place the power supply near to the
camera. If voltage drop occurs during
operation, the performance will be
unstable.
• Attach the cable conductors so that they
do not come into contact with the safety
cable.
E-12
Polyethylene
Core line
Insulation tape
5mm
3
/
"
(
)
16
DC 12 V or AC 24 V
Power Supply cable
Power Supply
terminal
Coaxial
cable
processing
terminal
Coaxial cable
Video signal cables
Connect the coaxial cables to the coaxial
cable processing terminal.
Note
Use the RG-59 or RG-6 video signal cable
(coaxial cable). The RG-11 cannot be
used.
• Perform the process shown on the left
diagram (above illustration) for the
coaxial cable tip before connecting.
DC 12 V or AC 24 V power supply cable
Connect a DC 12V or AC 24V power supply
cable to the power supply terminal. To pre-
vent connection errors or a cable disconnec-
tion, we recommend the use of lug plates for
the connections.
The following table shows the connection dis-
tances and connection cables provided that
2-conductor VVF cables (vinyl-insulated vi-
nyl sheath cables) are used.
100 m
Maximum extension
(330ft)
φ
Conductor
1.0mm
diameter
(AWG18) (AWG14) (AWG12) (AWG10)
• Do not allow input from both a DC 12 V
and AC 24 V power supply at the same
time.
• When using a DC 12 V power supply,
ensure that the polarities of the cable
are correct.
• The AC 24 V power supply should
conform to the following:
U-type:
Class 2 only
E-type:
Isolated power supply only
260 m
410 m
500 m
(850ft) (1300ft) (1640ft)
φ
φ
φ
1.6mm
2.0mm
2.6mm

Advertisement

loading