Dell Inspirion 510m Owner's Manual: Setting Up A Printer

Hide thumbs

Advertisement

On the What do you want to transfer? screen, select the items you want to transfer and click
7
Next.
After the information has been copied, the Completing the Collection Phase screen appears.
Click Finish.
8
To transfer data to the new computer:
On the Now go to your old computer screen on the new computer, click Next.
1
On the Where are the files and settings? screen, select the method you chose for transferring
2
your settings and files and click Next.
The wizard reads the collected files and settings and applies them to your new computer.
When all of the settings and files have been applied, the Finished screen appears.
Click Finished and restart the new computer.
3

Setting Up a Printer

NOTICE:
Complete the operating system setup before you connect a printer to the computer.
See the documentation that came with the printer for setup information, including how to:
Obtain and install updated drivers.
Connect the printer to the computer.
Load paper and install the toner or ink cartridge.
Contact the printer manufacturer for technical assistance.
Printer Cable
Your printer connects to your computer with either a USB cable or a parallel cable. Your printer may
not come with a printer cable, so if you purchase a cable separately, ensure that it is compatible
with your printer. If you purchased a printer cable at the same time you purchased your computer,
the cable may arrive in the computer box.
Connecting a Parallel Printer
Complete the operating system setup, if you have not already done so.
1
Turn off the computer.
2
NOTICE:
For best results, use a 3-m (10-ft) or shorter parallel cable.
Attach the parallel printer cable to the parallel connector on the computer and tighten the
3
two screws. Attach the cable to the connector on the printer and snap the two clips into the
two notches.
Setting Up Your Computer
35

Advertisement

   Also See for Dell Inspirion 510m

   Related Manuals for Dell Inspirion 510m

Comments to this Manuals

Symbols: 0
Latest comments: