Figure 3-2. Antenna Label; Figure 3-3. Rear Panel - Motorola APX 7500 Detailed Service Manual

Installation: Antenna Connections
a. The antenna should be mounted outside the building on the roof or a tower if at all possible.
b. As with all fixed site antenna installations, it is the responsibility of the licensee to manage the
site in accordance with applicable regulatory requirements and may require additional
compliance actions such as site survey measurements, signage, and site access restrictions
in order to ensure that exposure limits are not exceeded.
c. Dual Band models must have two antennas attached. Check the requirements of the antenna
supplier.
d. Ensure that the antenna cable can be easily routed to the Consolette. Route the antenna
cable as far away as possible from any nearby electronics and associated wiring.
e. Check the antenna location for any electrical interference.
f. Ensure that any transmitting radio antennas are separated from each other by at least 3 feet
(0.9 meter).
NOTE: The Antenna ports will be labeled appropriately for the ordered band combination.
The coaxial antenna cable connects to an N-type coaxial connector located on the rear panel of the
station. See Figure 3-3.
68009482001

Figure 3-2. Antenna Label

Figure 3-3. Rear Panel

3-3
September 9, 2011