Virtual Inputs; Clear Records; Set Date And Time - GE B90 Instruction Manual

COMMANDS MENU

7.1.1 Virtual inputs

COMMANDS  VIRTUAL INPUTS
 COMMANDS
 VIRTUAL INPUTS
The states of up to 64 virtual inputs are changed here. The first line of the display indicates the ID of the virtual input. The
second line indicates the current or selected status of the virtual input. This status is a state off (logic 0) or on (logic 1).

7.1.2 Clear records

COMMANDS  CLEAR RECORDS
 COMMANDS
 CLEAR RECORDS
This menu contains commands for clearing historical data such as the event records. Data is cleared by changing a
command setting to "Yes" and pressing the
"No."
7

7.1.3 Set date and time

COMMANDS  SET DATE AND TIME
 COMMANDS
 SET DATE AND TIME
The date and time can be entered on the faceplate keypad. The time setting is based on the 24-hour clock. The complete
date, as a minimum, must be entered to allow execution of this command. The new time and date take effect when the
key is pressed.
ENTER
When the relay is synchronizing to an external time source such as PTP, IRIG-B, or SNTP, the manually entered time is over-
written.
The timescale of the entered time is local time, including daylight savings time where and when applicable.
7-2
Virt Ip 1

Off
Virt Ip 2

Off

Virt Ip 64

Off
CLEAR USER FAULT

REPORTS? No
CLEAR EVENT RECORDS?

No
CLEAR OSCILLOGRAPHY?

No
CLEAR UNAUTHORIZED

ACCESS? No
CLEAR DIRECT I/O

COUNTERS? No
CLEAR ALL RELAY

RECORDS? No
key. After clearing data, the command setting automatically reverts to
ENTER
SET DATE AND TIME:

2000/01/14 13:47:03
B90 LOW IMPEDANCE BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL
CHAPTER 7: COMMANDS AND TARGETS
Range: Off, On
Range: Off, On
Range: Off, On
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes
Range: No, Yes.
Valid only for units with Direct Input/Output module.
Range: No, Yes
Range: YYYY/MM/DD HH:MM:SS