0FR4-05S
Specifying Destinations
This section describes how to specify fax destinations.
See the following sections to specify destinations.
Specifying destinations by entering the fax number
Specifying destinations using one-touch keys
Specifying destinations using coded dial codes
Specifying destinations using group addresses
Specifying destinations using the address book
Specifying Destinations in an LDAP Server (Fax)
When you are sending the same fax to multiple destinations simultaneously, see the following.
"Sending to Multiple Destinations at a Time (Sequential Broadcast)"
For the instructions on how to send a fax, see
Specifying destinations by entering the fax number
Specify the fax number using the numeric keys, [
To modify destinations
To cancel the entered destination
Press and hold [
To delete the last character of the entered destination
Press [
] (Clear).
Specifying destinations using one-touch keys
Press the one-touch key (01 to 19) in which the destination is registered.
To select a destination from the one-touch keys, you need to register destinations in these keys in advance.
"Registering and Editing One-Touch Keys"
When the wrong key is pressed
(1) Press [
] (Clear).
(2) Select <Yes> using [
To clear all the scan settings specified, press [
Downloaded from ManualsPrinter.com Manuals
] (Clear).
] and press [OK].
"Basic Procedures for Sending
] (Tone), and [
] (Symbols).
] (Reset).
Faxes."