Seagull Models SEA278 Assembly Manual page 13

1) Install the rubber grommets and brass
collets onto all servos. Test fit the servos
into the servo mounts.
2) Secure the servos with the screws pro-
vided with your radio system.
Elevator servo.
Rudder servo.
THROTTLE SERVO ARM
INSTALLATION.
Install adjustable servo connector in the
servo arm as same as picture below:
Loctite secure.
INSTALLING THE RECEIVER SWITCH.
Install the switch into the precut hole in
the side, in the fuselage.
Throttle servo.
Adjustable servo
connector.
Servo arm.
Throttle servo arm.
INSTALLING THE ENGINE SWITCH.
Trim and cut.
Switch.
3/32" Hole.
Trim and cut.
Switch.
13