Operating Modes; Exhaust Air Mode; Air Recirculation; Operating The Appliance - Siemens LC64PCC50T Instruction Manual

Table of Contents

Advertisement

Operating modes

en
ÇOperating modes
E xhaust air mode
O p e r a t i n g m o d e s
The air which is drawn in is cleaned
by the grease filters and conveyed to
the exterior by a pipe system.
The air must not be discharged into a flue that is
Note:
used for exhausting fumes from appliances burning gas
or other fuels (not applicable to appliances that only
discharge the air back into the room).
Before conveying the exhaust air into a non-
functioning smoke or exhaust gas flue, obtain the
consent of the heating engineer responsible.
If the exhaust air is conveyed through the outer wall,
a telescopic wall box should be used.

Air recirculation

The air which is drawn in is cleaned by
the grease filters and an activated
carbon filter, and is conveyed back into
the kitchen.
To bind odours in air recirculation mode, you
Note:
must install an activated carbon filter. The different
options for operating the appliance in air recirculation
mode can be found in the brochure. Alternatively, ask
your dealer. The required accessories are available
from specialist retailers, from customer service or from
the Online Shop.
6

1Operating the appliance

Switch on the extractor hood when you start
N ote:
O p e r a t i n g t h e a p p l i a n c e
cooking and switch it off again several minutes after you
have finished cooking. This is the most effective way of
removing the kitchen fumes.
Remove the protective film from the metal grease
Note:
filters before using the appliance.
Control panel
Explanation
Switches the fan on/off
#
2
Switches on fan setting 2
3
Switches on fan setting 3
Switches the lighting on/off
=

Switching the appliance on and off

Switching on the appliance
Press the # button.
The extractor hood starts at fan setting 1.
Selecting the fan setting
Press the 2 or 3 button to set the corresponding fan
setting.
Switching off the appliance
Press the # button.

Lighting

The lighting can be switched on and off independently
of the ventilation system.
Press the = button.

Advertisement

Table of Contents
loading

Table of Contents