One for All URC-7556 Instruction Manual page 10

(How to copy functions from your original working remote
The ONE FOR ALL 5 comes with a complete library of pre-programmed
codes. After you have set up the ONE FOR ALL 5 for your device, you may
find that there are one or more keys that you had on your original remote,
which do not have a place on the ONE FOR ALL keypad.
As a convenience, the ONE FOR ALL 5 offers a special Learning feature that
allows you to copy any function from your original remote control onto the
keypad of the ONE FOR ALL 5.
Before you start:
- Make sure your original remote control is working correctly.
- Make sure neither your ONE FOR ALL, nor your original remote control is
pointing at your device.
• Learning (Direct)
Example: To copy the "mono/stereo" function from your original TV
remote onto the "Radio"key of your ONE FOR ALL 5.
1 Place both remote controls (the ONE FOR ALL 5 and your original) on
a flat surface. Make sure the ends which you normally point at your
device are facing each other. Keep the remotes at a distance of
2 to 5 cm.
2
3
4
5
6
7 If you want to copy other functions within the same mode, simply repeat
steps 5 and 6 pressing the next key you want to copy by learning.
8
9 Learning is mode specific. To access your learned function,
press the appropriate device key first.
WW W.ONEFORA LL.COM
The Learning Feature
onto the ONE FOR ALL5)
Press and hold the MAGIC key until one of the device
keys will blink twice. The red LED underneath the
corresponding device key (depending on the device mode
that was selected) will blink once then twice.
Press 9 7 5 (the device key will blink twice).
Press the device key (on the ONE FOR ALL remote) to select
the mode to which you want to copy the learned function
(Example: TV key).
Press the key (on the ONE FOR ALL remote) where you
want to place the learned function (Example: "Radio" key).
The device key will flash rapidly.
Press and hold the key (on your original remote) that you
want to copy until the device key on the ONE FOR ALL blinks
twice (Example: "mono/stereo" key).
To exit the learning mode, press and hold MAGIC until
the device key blinks twice.
9