Configuring and calibrating the controller
Configuring and calibrating the controller
6
The configuration and calibration tools for Regard 3900 series controllers are used to view and change the configuration of the
controller, including the combination of internal control modules and the settings for the gas detection and warning devices. The
tools also allow zero point and span calibration.
Configure and calibrate the controller for all channels during initial installation and then when required during maintenance or
repair of the controller or gas detection system.
After completing any configuration or calibration, ensure that all alarms and warning devices operate as intended.
Configuration and calibration tools
For Regard 3900 and 3910, use the Dräger Regard 3900 Configuration Software. The software is a Microsoft Windows based
program that requires an interface unit (RS-232) and a compatible PC. The software and interface unit are available from Dräger.
See the Instructions for Use supplied with the software for full instructions.
For Regard 3920, use the built-in configuration system (see Annexe A on Page 30). Regard 3920 can also be configured using
the Dräger Regard 3900 Configuration Software if required.
25
Regard 3900 Series