Adjusting Phase Of Swing Gear And Gear (U/D) - Sony SCD-C333ES Service Manual

3-10. ADJUSTING PHASE OF SWING GEAR AND GEAR (U/D)

3 Let the swing gear through under the
h
chassis and engage its dowel
with the groove
2 Install the rotary encoder so that
its groove f comes to the position
shown in the figure.
1 Insert the shaft gear up to the
position where its shaft comes
out by 5 mm.
8 screw
(PTPWH M2.6)
7 gear (U/D)
5 stopper washer (FR)
g
f of rotary encoder.
g
f
circle mark
4 Push fully the shaft of shaft gear and
align the hole shape of gear (loading B).
6 screw
(PTPWH M2.6)
h
circle mark
gear (RV)
swing gear
Fig. A
q; screw
(PTPWH M2.6)
9 gear (RV)
Note: Align swing gear, a circle mark
on the gear (U/D), and the teeth
of gear (RV) to the position
showing in the Fig. A.
11