Panasonic KX-TGE240B Service Manual page 47

Case1: OK
AC power on
PIO01
0.05s
1.5s
Case2: NG1(fail to reset BT_IC)
AC power on
PIO01
1.5s
Case3: NG2 (fail to receive of UART signals)
AC power on
PIO01
1.5s
Case4: NG3 (fail to transmit of UART signals)
AC power on
PIO01
1.5s
Cross Reference:
Schematic Diagram (BT module) (for KX-TGE260/270 only) (P.78)
Note:
(*2) After replacing, need to adjust the frequency of BT.
Refer to Things to Do after Replacing X'tal (P.61)
1.95s
If BT_IC does not work, 1st and 2nd signals does not
appear.
If BT_IC fails to receive of UART, 2nd signal does not turn
to HIGH.
If BT_IC fails to transmit of UART, 2nd signal does not turn
to LOW.
KX-TGE240/242/243/244/245/260/262/263/264/270/272/273/274/275/TG454/TG465/TGEA20/TGA20
s
47
Check the circuit of around
POWER and RESET parts
of BT Module.
Check the circuit of around
UART communication (*1) of
main board and BT module.
still NG
Replace BT module (*2)