Tape Deck - Sony LBT-ZX10D Operating Instructions Manual

The language for the sound track cannot be
changed.
• Multilingual tracks are not recorded on the DVD
being played back.
• The DVD prohibits changing the language for the
sound track.
The subtitles language cannot be changed.
• Multilingual subtitles are not recorded on the
DVD being played back.
• The DVD prohibits changing the subtitles.
The subtitle cannot be turned off.
• The DVD prohibits turning off subtitles.
The angles cannot be changed.
• Multi-angles are not recorded on the DVD being
played back.
• The DVD prohibits changing the angles.
Tuner
There is severe hum or noise ("TUNED" or
"ST" flashes in the display).
• Set the proper band and frequency (page 42).
• Connect the antenna properly (page 9).
• Find a place and an orientation that provide good
reception, then set up the antenna again. If you
cannot obtain good reception, we recommend you
connect a commercially available external
antenna.
• The supplied FM lead antenna receives signals
along its entire length, so make sure you extend it
fully.
• Locate the antennas as far away from the speaker
cords as possible.
• Try turning off surrounding electrical equipment.
• Set the DVD power manage function to "DVD
POWER OFF" (page 42).
A stereo FM program cannot be received in
stereo.
• Press FM MODE until "MONO" disappears from
the display.

Tape deck

The tape does not record or play, or there is a
decrease in sound level.
• The tape heads are dirty (see "Cleaning the tape
heads" on page 79).
• The record/playback heads are magnetised (see
"Demagnetising the tape heads" on page 79).
The tape does not erase completely.
• The record/playback heads are magnetised (see
"Demagnetising the tape heads" on page 79).
There is excessive wow or flutter, or the sound
drops out.
• The capstans or pinch rollers are dirty (see
"Cleaning the tape heads" on page 79).
Noise increases or the high frequencies are
erased.
• The record/playback heads are magnetised (see
"Demagnetising the tape heads" on page 79).
The tape does not record.
• No tape is loaded. Load a tape.
• The tab has been removed from the tape. Cover
the broken tab with adhesive tape (page 79).
• The tape has reeled to the end.
Optional components
There is no sound.
• Refer to General item "There is no sound."
(page 71) and check the condition of the system.
• Connect the component properly (page 66) while
checking:
– if the cords are connected properly.
– if the cord plugs are firmly inserted all the way.
• Turn on the connected component.
• Refer to the operating instructions supplied with
the connected component and start playing.
continued
75 GB