Sony LBT-ZX10D Operating Instructions Manual page 10

6 For models equipped with a voltage
selector, set VOLTAGE SELECTOR to
the position of your local power line
voltage.
VOLTAGE SELECTOR
7 Connect the power cord to a wall
outlet.
The demonstration appears in the display.
When you press ?/1, the system turns on
and the demonstration automatically ends.
If the supplied adaptor on the plug does not
fit your wall outlet, detach it from the plug
(only for models equipped with an adaptor).
Note
Install this system so that the power cord can be
unplugged from the wall socket immediately in the
event of trouble.
8 Set the color system to PAL or NTSC
depending on the color system of your
TV.
The color system is factory set to NTSC for
region code 3 models, and PAL for other
region code models. Each time you perform
the procedure below, the color system
changes as follows:
y
NTSC
Use the buttons on the unit for the
operation.
1
Press ?/1 to turn off the system.
2
Press ?/1 while holding down
x (TAPE B).
The system turns on automatically and
the color system is changed. "COLOR
NTSC" or "COLOR PAL" appears in the
display.
10 GB
220V 120V
230-240V
PAL
Notes
• Keep the speaker cords away from the antennas to
prevent noise.
• Be sure to match the color of the speaker terminals on
the unit and the connectors.
• Be sure to connect the speakers securely and
correctly.
• You cannot set the color system in Power Saving
Mode (see "To cancel Power Saving Mode" on
page 60).
• When you playback a VIDEO CD recorded in a
different color system from the one you set to the
system, the picture image may be distorted.
To connect optional components
See page 66.
Inserting two R6 (size AA)
batteries into the remote
Operating a Sony TV
You can use the following buttons to operate a
Sony TV.
To
Turn the TV on or off
Switch the TV's input
source between the TV
and other input sources
Change the TV channels
Adjust the volume of the
TV speaker(s)
Note
If you do not use the remote for a long period of time,
remove the batteries to avoid possible damage from
battery leakage and corrosion.
Tip
With normal use, the batteries should last for about six
months. When the remote no longer operates the
system, replace both batteries with new ones.
Press
?/1
TV
TV/VIDEO
TV CH +/–
TV VOL +/–