Fuse Replacement - Honda Goldwing GL1100 Aspencade 1982 Owner's Manual

". If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
CAUTION:
". A
'ways rep/ace
used cotter pins with
new ones.
65
(4) Spare main fuse
(3)Main
fuse
*
Never use a fuse with a different rating
from that specified. Seriou~ damage to
the electrical system ora fire may result,
causing a dangerous loss of lights or
engine power at night or in traffic.
CAUTION:
*
Turn the ignition switch OFF before
checking or replacing fuses to prevent
accidental short-circuiting.
"Jd-';Wma
(2) Spare fuse
(l)
Fuse box
FUSE REPLACEMENT
The fuse box (I) is located in the top
compartment. Open the top compart-
ment cover and move air pump unit out of
the way tOOr access to fuses. Spare fuses are
located iit the fuse box.
The specified fuses are
SA.
lOA, and
ISA.
Always make sure the new fuse is the same
as the old one. When frequent fuse
f~i1u~e
occurs it usually indicates a short CUCUlt
or an' overload in the electrical system.
See your authorized Honda dealer for
repair. The main fuse
(3),
located near the
battery on the positive lead, is 30A.
the hinged license plate
pressed fully into the
Ih'Wdbi:IN
NOTE:
• Make sure
holder is
grommets.
Final drive case nuts:
35-45
N·m
(3.5-4.5
kg-m,
25-33 ft-Ib)
CAUTION:
". When installing the wheel, fit the
brake disc between the brake pads
.
i:arefully~
After installing the wheel, apply the
brake several times and then check that the
wheel rotates freely when released. Re-
check the wheel
if
the brake drags or if the
wheel does not rotate freely.
Axle holding bolt:
24-29
N·m
(2.4-2.9
kg-m,
17-21 ft-Ib)
64
NOTE:
• Tighten the nuts and bolts securely.
Axle nut:
80-100
N·m
(8.0-10.0
kg-m,
58-72 ft-Ib)
Shock absorber bolt and nut:
30-40 N·m (3.0-4.0 kg-m,
22-29 ft-Ib)