Tape Deck Section - Sony HCD-F50 Service Manual

QQ
3 7 63 1515 0
2. Aging Mode in Tape Deck Section (HCD-F100/FR1
only)
2-1. Operating Method of Aging Mode
1. Load a commercially available 10-minute tape into the decks
A and B respectively.
(If a 10-minute tape is not available, another tape may be used
but a cycle time will be longer.)
2. Select the function "TAPE".
3. Rewind tapes in advance by pressing 0 button respectively
on decks A and B.
4. Press three buttons
MEMO INPUT simultaneously.
5. Press TAPE A ( button. (This button triggers the aging
mode.)
6. The aging mode is activated if "AGING A" is displayed on
the fluorescent indicator tube.
7. In the aging mode, the aging is executed in a sequence given
in "2-2. Operation during Aging Mode".
The aging continues unless an alarm occurred.
8. To exit from the aging mode, press POWER button to turn
the set OFF.
2-2. Operation during Aging Mode
In the aging mode, the program is executed in the following
sequence.
1. A tape on FWD side is played for one minute.
2. PAUSE STOP is made.
3. Recording is made for 3 minutes. (For the deck not having the
record function, the play is executed. In this case, ( LED
does not light up.)
4. FF is executed up to the end of tape.
TE
L 13942296513
5. A tape is reversed, and the tape on REV side is played for one
minute.
6. PAUSE STOP is made.
7. Recording is made for 3 minutes. (For the deck not having the
record function, the play is executed. In this case, 9 LED
does not light up.)
8. FF is executed up to the end of tape.
9. Steps 1 through 8 are executed for the other deck.
10. Steps 1 through 9 are repeated unless an alarm occurred.
2-3. Deck Section Sequence
•
During the aging mode, decks are selected in the following
sequence:
Deck A (FWD) → Deck A (REV)
↑
Deck B (REV) ← Deck B (FWD)
www
.
http://www.xiaoyu163.com
ENTER , FUNCTION , and
↓
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Location:
[MAIN BOARD] (Component Side)
Q Q
3 6 7 1 3 1 5
co
.
– 35 –
9 4 2 8
CN402
CN401
1 2 3
CN404
IC461
0 5 8 2 9 9 4 2 8
m
9 9
9 9