Replacing the power button
Attention: Before you replace any FRU, be sure to read and understand Chapter 1 "Read this first: Important
safety information" on page 1.
To replace the power button, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 90.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 90.
4. Press the release tab
Figure 14. Pivoting the drive bay assembly upward
5. Disconnect the power button cable from the front bezel connector on the system board. See "Parts on
the system board" on page 34.
92
ThinkStation P310 Hardware Maintenance Manual
1
as shown and pivot the drive bay assembly upward.