Table of Contents
Advertisement
Lack of maintenance and failure to clean the microwave may lead to the wear of the device's coatings and may negatively
impact the device and cause dangerous situations.
1. Wash the external coatings with a soft cloth and water with soap. Clean and dry.
2. Wash all the stains and splashes on the internal coatings of the microwave oven using a cloth with soap. Clean and dry.
3. In order to remove the dried up food residues and odors, place a cup of lemon extract in the device's chamber and heat
it for 3 minutes on maximum power.
4. Do not clean the device with water.
Do not pour water into the ventilation holes.
Do not use abrasive or chemical cleaning agents. Thoroughly clean the door and make sure that food particles:
• are not building up
• do not prevent the door from closing properly.
Clean the inside of the microwave oven after each use with a mild cleaning agent but first let it cool down in order to avoid
injury.
13. STORAGE AND REPAIR OF THE MICROWAVE OVEN
During the storage or servicing of the microwave oven it is necessary to follow a few simple steps.
The microwave oven cannot be used if the door or door seals are damaged:
• damaged hinges
• damaged seals
• damaged or dented housing
Repairs should only be performed by a qualified technician specializing in microwave ovens.
Don't remove the housing of the microwave oven. If the microwave oven is damaged and requires servicing or you are not
sure of its condition:
• Disconnect the device from the power supply.
• Contact the nearest service center.
For temporarily storage of the device it is necessary to select a dry place free of corrosion.
Reason: Dust and moisture may damage or weaken the working parts of the microwave oven.
14. DISPOSING OF USED EQUIPMENT
You can return your old device after the end of use or when buying a new device at Stalgast. Send the device to us and a
specialized company will dispose of it in accordance with the Waste Electrical and Electronic Equipment Act (Journal of Laws
of 2005, No. 180, item 1495).
15. WARRANTY
The seller shall be liable under the warranty or guarantee.
In the event of damages resulting from the formation of limescale deposits in the device, they are not subject to repair under
warranty. The warranty also does not cover damages caused by external forces such as lightning, changes in supply voltage,
incorrect setting of the voltage value, supply from an inadequate power outlet, mechanical, thermal, chemical damages to the
equipment and the defects caused by them.
Warranty exchange does not cover such elements as: light bulbs, rubber components, heating elements damaged by lime
scale, screws and elements undergoing natural wear, e.g. burners, rubber seals and all kinds of mechanically damaged
elements.
- 10 -
Advertisement
Table of Contents
