Kenwood VR-6060 Instruction Manual page 43

In case of difficulty
Remote control unit
Symptom
Certain inputs cannot be selected using the
remote control.
Remote control operation is not possible.
•VR609/36-46/EN
Cause
• No setup codes registered at for the respec-
tive input(s).
• The remote control is set to a different opera-
tion mode.
• Batteries are exhausted.
• The remote control unit is too far away from
the main system, controlling angle is too large,
or there is an obstacle between the receiver
and the remote.
• The audio cords and system control cords are
not connected properly.
• No software is loaded in the source component.
• An attempt is made to play a tape which is
being recorded in the cassette deck.
• The remote control has not been set to the
operation mode for the component you wish
to control.
• The microprocessor of the remote control
malfunctions.
43
Remedy
• Register a setup code at the respective input(s).
• Press the source select keys or source POWER
keys to select the appropriate operation mode.
• Replace with new batteries.
• Operate the remote control unit within the
controllable range.
• Connect properly referring to "Setting up the
system".
• Place software in the source component you
want to play.
• Wait until recording has completed.
• Press the source select keys or SOURCE
keys to activate the operation mode for the
component you want to control before
operation.
• Reset the microprocessor.
10/24/01, 10:40 PM
‡°
fi
43
EN