Separate RX and TX
Connectors
Duplexer
7-6
Using this configuration, only one antenna is required for both
transmit and receive. The duplexer is mounted to the station top
panel and has a single N-type connector for the antenna. An N-to-
UHF adapter is provided.
In order to use two antennas, first disconnect the duplexer (if
equipped). Connect the Rx antenna to the UHF connector labeled
"RX" on the top panel, and the Tx antenna to the UHF connector
labeled "TX" (Figure 2). Please refer to the Antenna Spacing Chart
on page 4-1 in this manual.
The duplexer allows the PDR 3500 to use a single antenna for both
transmit and receive.
1. Connect the UHF connector labeled "RX" on the station top
panel, to the N-type connector labeled "RX" on the duplexer.
2. Connect the top panel UHF connector, labeled "TX," to the N-
type connector labeled "TX" on the duplexer .
3. Connect the antenna UHF-type connector to the connector
labeled "ANT" on the duplexer.
September 27, 2000
68P81093C75-O