Pipe Insulation - Panasonic WH-ADC0309H3E Service Manual

11.2.5.1 Wire Stripping and Connecting Requirement
Wire stripping
No loose strand when insert
(For UD07*E5* and UD09*E5* only)
•
Select required direction and apply protective bushing provided in accessories to protect cables from sharp edges.
•
Once all wiring work has been completed, tie the cable and cord together with the binding strap so that they do not touch other parts such as the
compressor and bare copper pipes.
Outdoor Unit

11.2.6 Pipe Insulation

1 Please carry out insulation at pipe connection portion as mentioned in Indoor/Outdoor Unit Installation
Diagram. Please wrap the insulated piping end to prevent water from going inside the piping.
2 If drain hose or connecting piping is in the room (where dew may form), please increase the insulation by
using POLY-E FOAM with thickness 6 mm or above.
Indoor/outdoor
connecting terminal
board
5 mm or more
(gap between wires)
Terminal Board
Cord clamp
Banding strap 3
Connecting cable
(refer below
diagram for its
guiding)
Conductor fully
insert
ACCEPT
Protective
bushing 4
Apply cut
DETAIL OF CONNECTING CABLE GUIDING
69
Conductor not
Conductor over
insert fully insert
PROHIBITED PROHIBITED
Selection
of direction