Table of Contents
Advertisement
Chapter 2
Switching on
Follow the instructions on this page on how to switch on your TV set and
the remote control before going on to following pages describing how to
use the channel set-up procedure.
1. Insert two AAA batteries in the remote control.
Precautions on using batteries:
-
- Make sure you use the correct polarity.
- Do not mix new and used batteries.
- Do not use rechargeable batteries.
- Do not expose batteries to excessive heat
this could cause them to leak or explode.
- Remove the batteries from the remote control if you are not using it
for a long period of time.
2. Connect the power cable FIRST to the television, THEN to a mains
socket.
(Note: If the power cable is connected to the television, please only
connect the power cable to the mains socket.)
Your TV set should only be connected to an AC supply. It must not be
connected to a DC supply. If the plug is detached from the cable, do
not, under any circumstances, connect it to a mains socket, as there is
a risk of electric shock.
socket of the television might differ depend on the model.
3. Connect an outside aerial to the ANTENNA/CABLE IN socket at the
back of the TV set.
The aerial socket (75 OHM - VHF / UHF / cable) can be used for
Note: If you want to receive the
please connect a coaxial cable to the ANTENNA/CABLE IN socket at
the back of the TV set.
4. When powered on, the TV will be
mode.
If the power indicator lights up, the TV set is in standby mode. Press
the
button on the remote control or on the TV set to turn on the TV.
Switching off
To put the TV set into standby mode, press the
remote control. The TV set remains powered up, but with low energy
consumption.
To switch off the TV set, unplug the mains socket from the mains outlet.
11
Connections and Setup
. The location of the power
s
g i
n
a
f l
o r
m
y
o
r u
c
a
u t
n r
e
d
o
n
i d
e r
c
y l t
b
e l
r o
c
a
b
e l
b
o
, x
r o
b
e
n i
s
a t
n
d
b
y
button on the
Hide quick links:
Advertisement
Table of Contents
