Inspection & Maintenance....................... Warranty............................INTRODUCTION Thank you for purchasing the Bushranger High Pressure Washer. This manual explains how to correctly use the High ™ Pressure Washer. Before using it, please read this operator’s manual carefully, operate the machine correctly and engage in your task safely.
ITEM DESCRIPTION Hose Reel with 7mt High Pressure Hose. (Also available as a Spare Part). Hose Reel Handle. Lance. (Also available as a Spare Part). High Pressure Gun. (Also available as a Spare Part). Pressure Washer with Induction Motor. 5mt/24OV Plug. On/Off Switch.
• The operating method to be followed in the event of accident (e.g. contact with detergents: rinse with an abundance of clean water) or breakdown to prevent unsafe situations. • This machine has been designed for use with the cleaning agent supplied or recommended by our local BushRanger Dealer .
Page 5
The machine is not intended to be connected to the potable water mains. • To ensure the machine safety, please only use original spare parts (including nozzle) from your local BushRanger Dealer or approved by your local BushRanger Dealer .
Page 6
Warning: • Use only 3-wire extension cords that have 3-prong grounding-type plugs and 3-pole cord connectors that accept the plug from the machine. Use only extension cords that are intended for outdoor use and the socket must be of watertight construction.
OPERATING INSTRUCTIONS Please Note: This unit is to be connected to a cold water source ONLY. Please Note: The motor of this pressure washer will NOT run. It will only operate when the trigger is squeezed. • Connect the outlet hose to the washer and connect the spray gun to the outlet hose. •...
ADJUSTABLE SPRAY NOZZLE • Turn off the spray lance first, hold the rear part of spray nozzle, then turn the front part of spray nozzle anti-clockwise. Water may be sprayed out from the spray nozzle in fan shapes (Fig. 2); Turn the front part of spray nozzle clockwise, water may be sprayed out from the spray nozzle linearly (Fig.
• Remove additional debris by back-flushing water through the nozzle. To do this, place end of a garden hose (with water running ) to the end of nozzle for 30-60 seconds. MAJOR TECHNICAL DATA ITEM PW110 PW130 PW150 Working pressure. 11MPa (1595PSI)
POSSIBLE PROBLEM AND SOLUTION FAULT PROBABLE CAUSE REPAIR When switched on the machine • Plug is not well connected or • Check plug, socket. will not start working. electric socket is faulty. • Check that the main voltage • The main voltage is is adequate.
After working, make sure there is no water in the pump and the hose. This is a good time to use “pump saver”. If the machine need to be repaired in the warranty period, please return the machine to your local BushRanger dealer. You need to provide the certificate of purchase in order to repair or receive a replacement.