Related Manuals for Tenmars TM-730
Summary of Contents for Tenmars TM-730
- Page 1 Tenmars Temperature / Humidity Meter TM-730 User’s Manual HB2TM7300001 TENMARS ELECTRONICS CO., LTD...
-
Page 3: Table Of Contents
CONTENTS PREFACE......................1 CHARACTERISTICS ..................1 SPECIFICATIONS .....................1 General Specifications ..................1 Electrical Specification: (Temperature: 25°C, Humidity: <90% RH)....2 Accuracy:......................2 OPERATING INSTRUCTIONS................3 LCD Display Functions: .................3 Instrument description..................3 MODE: ......................3 CAL/°C/°F Button: ..................4 MAX/MIN/AVG Button ..................4 Data Hold Button ....................4 4.10 Power Button:....................5 4.11 Auto Power Off:....................5 4.12 Enable/Disable Auto Power Off:..............5 End of life ......................5... -
Page 4: Preface
TM-730 PREFACE Thank you for your patronage please read these operating instructions carefully so that you may correctly operate the Temperature / Humidity Meter, allowing it to perform all its intended functions at optimum level. The Temperature /Humidity Meter use a highly accurate sensor chip to measure relative humidity and temperature. -
Page 5: Electrical Specification: (Temperature: 25°C, Humidity: <90% Rh)
TM-730 Weight : 80g (excluding the battery) ● Accessories : User manual, battery, and carrying case. ● Operating Temperature and Humidity : 0°C ~ +60°C, <95% ● RH. (non-condensing) Storage Temperature and Humidity : -10 to 60°C, <70% ● RH. (non-condensing) 3.2 Electrical Specification: (Temperature: 25°C,... -
Page 6: Operating Instructions
TM-730 OPERATING INSTRUCTIONS 4.4 LCD Display Functions: Low Battery Detect Primary Display Secondary Display Auto-Power Off Indicator Data Hold MAX Data Hold AVG Reading MIN Data Hold Relative Humidity 10. °C Temperature unit 11. DEW-POINT 12. WET-BULB 13. °F Temperture unit 4.5 Instrument description... -
Page 7: Cal/°C/°F Button
TM-730 4.7 CAL/°C/°F Button: Calibration point 55%RH and 25℃. 1. Prepares 55%RH or 25℃ environment. 2. Press CAL button and POWER button more than 2 second to calibration. 3. Put the meter in 55%RH or 25℃ environment 4. Presses the MODE key to be select humidity or... -
Page 8: Power Button
TM-730 4.10 Power Button: Press the ” ” button more than 2 second to power on the meter. 4.11 Auto Power Off: To save battery life, the meter powers down automatically after approximately 12 minutes of inactivity. 4.12 Enable/Disable Auto Power Off: You can disable or enable Auto Power Off by pressing the ”... -
Page 9: Warning And Precautions
TM-730 Warning and Precautions: Please refrain from operating the Temperature / Humidity ● Meter in an environment with drastic temperature and humidity changes. Do not store the thermometer in an environment prone to high temperature, high humidity, or vigorous vibrations. Avoid exposing the thermometer in a chemical-contaminated environment. -
Page 10: Accessories
TM-730 will also respond to unwanted signals that may be present within the measurement circuit. Users should exercise care and take appropriate precautions to avoid misleading results when making measurements in the presence of electronic interference. Accessories: User manual. ●... - Page 12 Solar power meter, Radiation meter, Clamp meter, Multimeter Phase Rotation tester, Digital Insulation tester Our products of high quality are selling well all over the world TENMARS ELECTRONICS CO., LTD 6F, 586, RUI GUANG ROAD, NEIHU, TAIPEI 114, TAIWAN. E-mail: service@tenmars.com http://www.tenmars.com...
Need help?
Do you have a question about the TM-730 and is the answer not in the manual?
Questions and answers