Setting the clock
The time is displayed using the 12-hour clock.
1
Check the set is switched to standby mode.
(see Basic Functions, Switch on/to
standby)
➜--:-- flashes by default if the clock is not set..
2
On the set, press CLK/DISP (or
CLOCKSET on the remote control)
➜
The hour digits start flashing (AM 12: 00 by
default).
3
Hold down or press TUNING/CLOCK + or
- repeatedly to set the hour. Release
TUNING/CLOCK + or - when you have
reached the correct setting.
4
Press CLK/DISP to confirm the setting.
➜
The minute digits start flashing.
5
Repeat step 3 to set the minute.
6
Press CLK/DISP to confirm the setting.
➜
The clock shows the set time.
Helpful hints:
– You may lose your clock setting when the power
cord is disconnected or power failure occurs.
CLOCKSET
DSC
PICTURE
VOL
Using the TV screen
The set is equipped with a 7" TFT LCD
monitor. You can watch TV on it. If you insert a
disc, it will serve as an additional display for
messages (e.g. PLAY, STOP), and information
stored on the disc.
3
1
Press PUSH at the bottom of the set to release
TV panel.
2
Pull the down the panel (maximum 115
3
Turn around the panel to find the screen.
4
Adjust the screen to a suitable angle (maximum
0
270
).
Installation
1,2
115
maximum
PUSH
4
270 maximum
0
).
13