Troubleshooting - Electrolux EKC6461AOK User Manual

22 www.electrolux.com
To replace the glass panels,
do the same steps in
reverse. Before you lower
the trim, attach the A trim
part to the door. Refer to the
image.
11.7 Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.

12. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
12.1 What to do if...
Problem
You cannot activate the
appliance.
You cannot activate the
appliance.
Residual heat indicator
does not come on.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
The back lamp
1. Turn the lamp glass cover
2. Clean the glass cover.
3. Replace the oven lamp with a
4. Install the glass cover.
Possible cause
The appliance is not con‐
nected to an electrical sup‐
ply or it is connected incor‐
rectly.
The fuse is released.
The zone is not hot be‐
cause it operated only for a
short time.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
or deactivate the circuit breaker.
The lamp glass cover is at
the back of the cavity.
counterclockwise to remove it.
suitable 300 °C heat-resistant oven
lamp.
Use the same oven lamp type.
Remedy
Check if the appliance is
correctly connected to the
electrical supply.
Make sure that the fuse is
the cause of the malfunc‐
tion. If the fuse releases
again and again, contact a
qualified electrician.
If the zone operated suffi‐
ciently long to be hot,
speak to an Authorised
Service Centre.
Activate the oven.
Set the clock.
Make sure that the settings
are correct.