Reversing Opening Of Fully Insulated Doors - Electrolux Prostore PS06R1F User Manual

B.2.6 Reversing opening of fully insulated doors
ATTENTION
Disconnect the appliance
from the power supply be-
fore carrying out the door
reversing procedure.
The refrigerated cupboards are normally supplied with right
opening.
When changing to left opening, proceed as follows:
open the control panel, loosening the 2 screws located
` `
between the panel and door;
remove the cap located on the left side and re t it on the
` `
right side of the control panel;
undo the 2 screws of the upper bracket "A", the hinge
` `
fastening screw "B" and the 2 xing screws (Detail 1);
remove the cap "C" from the left side and place it on the
` `
right side (Detail 2);
remove the door, pull out the hinge from its seat, move
` `
it from the right to the left and t it in the hole as shown
in the gure (Detail 3);
position the upper bracket "A" between the door and the
` `
roof of the appliance, tightening the xing screws (Detail 3);
remove the lower bracket "D" from its seat and re t it in
` `
the special seat on the opposite side (Detail 4);
position the door on the lower bracket "D";
` `
before tightening the screws, align the door with the
` `
cabinet panel, adjusting the lower and upper brackets
and making sure the seal is perfectly tted on all sides;
then tighten the bracket xing screws;
` `
close the control panel again, securing the 2 screws (pre-
` `
viously loosened) between the panel and door.
A
B
Detail 1
2
C
1
2
3
D
Detail 4
3
Detail 2
1
Detail 3
75