Download Print this page

Testing The System; Using The 5 Test Key - Honeywell VISTA-128BPT User Manual

Commercial burglary partitioned security system with scheduling
Hide thumbs

Advertisement

• • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
(To Be Conducted Weekly)
U s i n g t h e
5
The TEST key puts your system into Test mode, which allows each protection point to be checked for
proper operation.
1.
Disarm the system and close all protected windows, doors, etc. READY should be displayed.
2.
Enter your security code and press the
3.
The external sounder should sound for 3 seconds and then turn off. If the sounder does not
sound, it may be due to dialer communication activity.
Wait a few minutes and try again. If the sounder still does not sound, CALL FOR SERVICE
IMMEDIATELY.
NOTE: This command will cause the panel to look for the battery and if seen, activates
the alarm output (siren) for 3 seconds, and will clear a low battery if it is a
successful test.
The Keypad Displays:
BURG WALK TEST
IN PROGRESS
The test includes all Fire, Burglary and Panic zones.
Each time a protection zone is faulted (opened), the keypad should beep three
times. If the sounder does not sound, CALL FOR SERVICE IMMEDIATELY.
In the case of wireless transmitters, sensitivity of the wireless receiver will be reduced
by 50% for the Go/No Go test.
NOTE: If two wireless receivers exist, the system beeps 1 time for receiver # 1,
The keypad displays the zone number and alpha descriptor while a door or window
remains open or while a detector remains activated.
Section 31: Testing the System
T E S T K e y
2 times for receiver # 2, and 3 times if both receivers received the
signal.)
5
key.
TEST
57

Hide quick links:

Advertisement

loading

  Related Manuals for Honeywell VISTA-128BPT

This manual is also suitable for:

Vista-250bptVista-128bptsia