Reset Sources Register - Philips P89LPC902 User Manual

Philips Semiconductors
RESET
RSTSRC
Address: DFH
Not bit addressable
Reset Sources: Power-on only
Reset Value: xx110000B (This is the power-on reset value. Other reset sources will set corresponding bits.)
BIT SYMBOL
RSTSRC.7-6 -
RSTSRC.5 BOF
RSTSRC.4 POF
RSTSRC.3 R_BK
RSTSRC.2 R_WD
RSTSRC.1 R_SF
RSTSRC.0 R_EX
2003 Dec 8
7 6
- - BOF
FUNCTION
Reserved for future use. Should not be set to 1 by user programs.
Brownout Detect Flag. When Brownout Detect is activated, this bit is set. It will remain set
until cleared by software by writing a '0' to the bit. (Note: On a Power-on reset, both POF
and this bit will be set while the other flag bits are cleared.)
Power-on Detect Flag. When Power-on Detect is activated, the POF flag is set to indicate
an initial power-up condition. The POF flag will remain set until cleared by software by
writing a '0' to the bit.. (Note: On a Power-on reset, both BOF and this bit will be set while
the other flag bits are cleared.)
Break detect reset. If a break detect occurs and EBRR (AUXR1.6) is set to '1', a system
reset will occur. This bit is set to indicate that the system reset is caused by a break detect.
Cleared by software by writing a '0' to the bit or on a Power-on reset.
Watchdog Timer reset flag. Cleared by software by writing a '0' to the bit or a Power-on
reset.(NOTE: UCFG1.7 must be = 1).
Software reset Flag. Cleared by software by writing a '0' to the bit or a Power-on reset.
External reset Flag. When this bit is '1', it indicates external pin reset. Cleared by software
by writing a '0' to the bit or a Power-on reset. If RST is still asserted after the Power-on
reset is over, R_EX will be set.
Figure 9-2: Reset Sources Register
5 4 3
POF R_BK
74
User's Manual - Preliminary -
P89LPC901/902/903
2 1 0
R_WD R_SF R_EX