Advertisement
Before you connect anything, make sure that your system is disconnected from power. Also double
check the polarity of the ribbon cable, the red cable should match the 12V rail both on the module and
on the bus board!
TROUBLESHOOTING
This may be the common problems and solutions:
Inputs don't work as they should
Check out the soldered joints again. If needed heat up them and add a bit of solder.
See the installed positions of jumpers (see page 11)
Check out the ICs orientation (see page 9)
RGB LED is not working how it should
Is it oriented the right way? (see page 6)
If you are having some more trouble, the best thing is to take a nap! Especially late at night!
If you are still in trouble, you can send the detailed description of the problem with enclosed
highresolution photos on
If you think that you are unable to make the module work on your own, consider our "
service.
d iy@bastlinstruments.com
.
12
C ome to Daddy
"
Advertisement
