Table of Contents
Advertisement
SERVO AND PUSHROD
INSTALLATION.
1) Place the rudder servo in the fuselage
with the output shaft to the front of the
fuselage. Position the servo so the edge
toward the center is centered in the open-
ing. Use a pencil to transfer the positions
for the mounting screws on the servo
tray.
2) Remove the servo from the fuselage.
Use a pin vise and drill bit to drill the four
holes for the servo mounting screws.
1.5mm
3) Use a screwdriver to thread a servo
mounting screw into each of the holes
to cut threads in the surrounding wood.
Remove the screw before moving to the
next step. Prepare all four mounting
holes at this time.
WWW.SEAGULLMODELS.COM
4) Place 2-3 drops of thin CA in each hole
to harden the surrounding wood.
5) Insert the Z-bend from the pushrod
wire through the hole in the servo horn.
Thin CA.
15
Advertisement
Table of Contents
