Making Wi-Fi Settings By Pin Code Setup (Wps) - Epson L385 SERIES User Manual

User's Guide
2. Press button on the printer's control panel until the green light on the left and the orange light on the right
alternately blink (approximately 3 seconds).
The connection setting will start. Green light on the left and orange light on the right will simultaneously turn
on when the connection is established. Orange light on the right will be automatically turned off within 5
minutes.
Note:
The printer is in a connection error status when green light on the left is off and orange light on the right is blinking.
After clearing the printer error by pressing the
the printer and try again. If it still does not work, print a network connection report and check the solution.
Related Information
"Checking the Network Connection Status" on page 21
&
"When You Cannot Make Network Settings" on page 96
&

Making Wi-Fi Settings by PIN Code Setup (WPS)

You can connect to an access point by using a PIN code that is printed on the network status sheet. You can use
this method to set up if an access point is capable of WPS (Wi-Fi Protected Setup). Use a computer to enter a PIN
code into the access point.
1. Load papers.
2. Hold down the button on the printer's control panel for at least 10 seconds.
The network status sheet is printed.
Note:
If you release the
information is not printed on this report.
Network Settings
button within 10 seconds, a network connection report is printed. Note that PIN code
button on the control panel, reboot the access point, place it close to
20