18 Monitoring EEG
The content of EEG Reports is always the same and does not need to be configured.
To print an EEG Report, in the
Alternatively, you can select the CSA and use the
To modify the buffer and trendline settings on the CSA Report, in the
trendlines for the SEF numeric on and the buffer time from Buffer C.
CSA on EEG Rep.
EEG Safety Information
Do not touch the patient, or table, or instruments during defibrillation.
When connecting electrodes and/or patient cables, ensure that the EEG leads and connectors do not
come into contact with other conductive parts or earth.
High-frequency Surgery - To reduce the hazard of burns, the EEG electrodes should not be located
between the surgical site and the electrosurgical unit return electrode.
EEG and Electrical Interference
Implanted devices (e.g. cardiac pace makers), other patient connected equipment, and other equipment
near the patient (e.g. high-frequency surgical units) can cause interference on the waveform, numerics,
and the CSA presentation.
Radiated field strengths above 1 V/m and patient signals ≤ 50 µV may cause noise on the EEG waves
at various frequencies. Therefore, it is recommended to avoid the use of electrical radiating equipment
in close proximity to the patient monitor. The noise does not influence the measurement accuracy.
Interference from ECG can be eliminated by adjusting the low filter settings.
. If you do not change these settings, the monitor will use the default settings with the
This menu entry lets you
Choose one of the three pre-configured buffer times.
Switch the trendline of the specific numeric on or off.
pop-up key to start the report.