Speaker Assembly Option - Panasonic SC-BT735 Operating Instructions Manual

Use of the speaker cable stickers is convenient
3
when making cable connections.
e.g. Front speaker (L)
A Speaker cable sticker (included)
B Connector
Speaker cable sticker
1 FRONT (L)
2 FRONT (R)
3 SURROUND (L)
4 SURROUND (R)
5 CENTRE
6 SUBWOOFER
Be sure to match the number on each sticker with the
connector colour.

Speaker assembly option

[BT330]
Thread the speaker cable
through the base.
Leave about 120 mm
You can remove and use the cable from
the stand. To reattach the cable, refer to
page 42.
[BT735] [BT330]
∫ Preventing the speakers from falling
≥Consult a qualified housing contractor concerning the appropriate procedure when attaching to a concrete wall or a surface that
may not have strong enough support. Improper attachment may result in damage to the wall or speakers.
≥Use a string of less than ‰ 2.0 mm, which is capable of supporting over 10 kg.
e.g., [BT735]
FRONT
Lch
Colour
WHITE
RED
BLUE
GREY
GREEN
PURPLE
Attach the speaker.
Connecting the speaker cables. Insert the wire fully,
4
taking care not to insert beyond the wire insulation.
e.g. Surround speaker [BT230]
Push!
≥ Be careful not to cross (short-circuit) or reverse the polarity of the
speaker wires as doing so may damage the speakers.
≥ Don't use a front speaker as a surround speaker or vice versa. Verify
the type of speaker with the label on the rear of the speaker before
connecting the appropriate cable.
≥ To avoid injury by falling or dropping the speaker, place the speaker cables
with care not to stumble or hook.
≥ Do not hold the speaker in one hand to avoid injury by dropping the
speaker when carrying.
Insert the wire fully.
Push!
r: White
s: Blue line
Press into the groove.
Tighten securely.
Slide into the
groove.
A String (not included)
Thread from the wall to the speaker and tie tightly.
B Rear of the speaker
C Screw eye (not included)
D Wall
E Approx.150 mm
r: White
s: Blue line
VQT2Q52
13