Table of Contents
Advertisement
Module Docking
Module Removal
Before removing a module, please ensure that the camera is powered off.
If your camera has a module docked, remove by following these instructions:
1. Place index finger onto
the module notch.
Detaching the module exposes the female connector and module dock area.
A tool may be used alternatively to remove the module.
Module Attachment
Before installing, please ensure that the camera is powered off.
1. Place the module on the camera,
ensuring that the 30 pin connector is
above the camera's female connector.
Warning: Please ensure that the connectors are plugged together; if securement pins have
locked into place, but the connector remained undocked; remove the module and repeat
attachment. During step 2, you may press the module firmly on the connector side area, to
ensure connector docking before securement pins locking into place.
2. Pull outwards, pivoting
on the module.
2. Press down on both ends
simultaneously, until the module
clicks into place.
EN
9
Advertisement
Table of Contents
