Table of Contents
Advertisement
Help with the appliance
en
3
Help with the appliance
H e l p w i t h t h e a p p l i a n c e
Faults
The appliance will not start.
Creasing.
Water is leaking out.
The programme does not start Make sure that:
Programme duration displayed
changes as drying progresses.
60
Cause/remedy
Check the mains plug and the fuses.
Load exceeded or incorrect programme selected for a type of fabric.
■
All the required information can be found in the programme
table.~ Page 23
Remove laundry from the drum as soon as the drying programme
■
has finished. Creasing occurs when clothing is left in the drum.
The appliance may be positioned at an angle. Level the appliance.
■
In the base unit, make sure that:
■
– The heat exchanger cover is properly locked.
– There is no dirt or debris on the heat exchanger cover's seal.
~ Page 51
If the optional drain hose* is installed, make sure that the drain hose
■
is correctly connected. ~ Page 46
The door is closed
■
The w 3 sec (Child lock) has been deactivated
■
You have pressed I (Start/Pause)
■
Note:
If the programme has been delayed by setting B (Ready in), the
programme starts at a later point.
If à•‹˜ is shown on the display for five seconds after you switch the
appliance on or off, this means that the appliance is in shop mode.
Switch shop mode off as follows:
Switch the appliance off and then on again.
1.
2.
Wait until the à•‹˜ message goes out in the display.
3.
Press and hold I (Start/Pause) for at least five seconds.
‹"" appears in the display and the appliance switches
itself off automatically. Shop mode is now deactivated
and you can use the appliance as normal.
Not a fault. The moisture sensor measures the residual moisture in the
laundry and adjusts the programme duration (with the exception of timed
programmes).
Advertisement
Table of Contents
