Installation And Connection; Scope Of Delivery; Installing And Connecting The Dryer - Siemens WT45M230GB Installation And Operating Instructions Manual

Installation and connection

en
5
Installation and
connection

Scope of delivery

I n s t a l l a t i o n a n d c o n n e c t i o n
Dryer
■
Installation and operating
■
instructions
Basket for woollens
■
Condensation drain*
■
Installing and connecting the
dryer
:
Warning
Risk of death!
There is a risk of electric shock as the
dryer is operated with electricity.
Check the dryer for visible damage.
■
You must not operate the dryer if it is
damaged.
Before connecting the dryer to the
■
power supply, ensure that the
electric voltage specified on the
rating plate matches the voltage of
your socket.
Only use earth-leakage circuit
■
breakers with the following symbol:
z.
Ensure that the mains cable is not
■
kinked or trapped, and that it does
not come into contact with heat
sources or sharp edges.
:
Warning
Children may lock themselves in the
dryer, putting their lives at risk!
Do not set up the dryer behind a door
or sliding door, as this may obstruct the
dryer door or prevent it from opening.
Caution!
Risk of injury
Due to the heavy weight of the dryer,
■
you may injure yourself if you lift it.
Do not lift the dryer on your own.
* Depending on the model
14
*
You could cut your hands on the
■
sharp edges of the dryer. Do not
hold the dryer by the sharp edges.
Protruding parts on the dryer may
■
break off when it is lifted or pushed.
Do not move the dryer by holding
onto protruding parts.
Caution!
Risk of material damage to the dryer or
fabrics.
Check the dryer for damage caused
■
during transportation. Never operate
a dryer if it is damaged.
Any residual water in the dryer may
■
freeze and damage the dryer. Do not
install the dryer in rooms that are at
risk of frost.
During installation, ensure that:
The dryer is placed on a clean, level
■
and firm surface,
The mains plug can be accessed at
■
all times,
The air inlet on the dryer is kept clear
■
and there is sufficient ventilation,
The area around the dryer is kept
■
clean and
The dryer is levelled using the
■
threaded feet.
Check the alignment of the
Note:
appliance with a spirit level and
correct if necessary. Change the
height by turning the appliance feet.
All appliance feet must stand firmly
on the ground.
Incorrect alignment may cause high
noise levels, vibrations and improper
movement of the drum.
If in doubt, have the appliance
Note:
connected by a specialist.