OPERATING THE ESPRESSO MACHINE
You can change your selection mid-brew
by turning the selection dial to a new
selection before brewing ends.
Automatic standby mode
When the Espresso Machine is plugged in, it automatically goes into stand-by mode. You
must either press the brew button or rotate the dial to wake up the Espresso Machine.
After 9 minutes of non-use, it turns to a low-consumption mode, and the heater powers off.
If you prefer to change this standby time, you can set it for 15 minutes, 20 minutes, or 30
minutes, using the following directions:
When the Espresso Machine is turned
on, the LED will flash as it warms up.
When the machine is ready, the LED
will glow continuously.
After your espresso is finished brewing,
lift the handle to its fully upright position
to drop the used capsule into the
NOTE: Eject the capsule after each
coffee or before turning off the machine.
The capsule disposal container holds up
to 14 used capsules. See the "Care and
cleaning" section for more information.
Rotate the selection dial until the light
is over the left most position and hold
for 6 seconds. The light will hold steady
before changing to 2 blinks per second.
The Espresso Machine is now ready to
reset the standby time.