Advertisement
USING THE SLEEP TIMER
MAINTENANCE
When you are preparing to fall asleep, this timer switches
off the power automatically
when the set time in the
operating
mode has elapsed. There is a choice of 6 set
times: 120, 90, 60, 30, 20 and 10 minutes.
1. Press the SLEEP switch. The "SLEEP OFF" appears
and previous sleep time setting display blinks.
eg: SLEEP
OFF
120
If the time display lights continuously,
it means that
the SLEEP timer is operating.
2. Press the SLEEP switch before the 10 seconds elapse,
and set the desired sleep time.
Every time the SLEEP switch is pressed,
the sleep
time display
will blink and change
in the following
sequence:
120-90
-60-30
-20-
10-(released)-
120- . . .
When the SLEEP switch
is pressed
again while
"1 O" is blinking
or when the CLEAR switch
is
pressed,
a return is made to the original display
and the SLEEP timer setting mode is released.
3, Either press the MEMORY switch within 10 seconds
or allow the 10 seconds to elapse. The selected sleep
~time changes from blinking to lit and after 2 seconds,
n
return is made to the original display and the SLEEP
timer starts operating,
(The "SLEEP
OFF" display
remains.)
To check the remaining
sleep time:
[f the SLEEP switch is pressed while the SLEEP timer
is operating,
the remaining
time will be displayed.
A
return is made to the original display if the MEMORY
switch is pressed or 10 seconds are allowed to elapse.
To release the SLEEP timer while it is operating:
Press the SLEEP switch and then press the CLEAR
switch. The timer is also released when the power is
switched off.
Timer priorities
When the power is switched on by the WAKE UP timer
and when, during the WAKE UP timer operation,
the
actual time reaches the ON time setting of the ON/
OFF timer, the ON/OFF timer will not operate and it will
-
be released.
When the power is switched on by the ON/OFF timer
and when, during the ON/OFF timer operation,
the
actual time reaches the wake-up
time setting of the
WAKE UP timer, the WAKEUP
timer will not operate.
In this case, however,
the WAKE UP timer is not
released.
When the same time has been set for both the WAKE
UP timer and the ON time for the ON/OFF timer, the
ON/OFF timer has precedence
and will operate.
When the SLEEP timer has been set during an opera-
tion by the ON/OFF timer or WAKE UP timer, the
power will be switched
off after the time set by the
SLEEP timer has elapsed. The ON/OFF timer will be
released. (The SLEEP timer takes precedence,)
Cleaning the deck 1 and 2 heads (Fig. 17)
To ensure
playback
and recording
with good-quality
sound, use cotton swab to clean the heads, pinch rollers
and capstans of the decks after about every 10 hours of
use.
If the dirt persists, soak the swab in a little methylated
spirit or head cleaning fluid and then clean.
Main unit
Use a soft cloth to remove dirt on the main unit.
If the dirt persists, dip a soft cloth into a diluted solution
of neutral detergent, wring it out, wipe away the dirt, and
then take up any moisture with a dry cloth.
Do not use benzine, thinners
or alcohol since they will
mar the finish of the surfaces. Also take care not to use
insecticide
sprays near the system.
-22-
Advertisement
