GMC Terrain 2017 Owner's Manual page 28

: Press to unlock the driver door
or all doors. See Vehicle
Personalization 0 118. The turn
signal indicators may flash to
indicate unlocking has occurred. For
more information see Vehicle
Personalization 0 118. Pressing
may also disarm the theft-deterrent
system. See Vehicle Alarm
System 0 35.
For vehicles with the manual
liftgate, press twice within
five seconds to unlock the liftgate.
: If equipped with the power
liftgate, press and hold until the
liftgate begins to move. Press again
to stop the power liftgate.
: Press and release one time to
initiate vehicle locator. The exterior
lamps flash and the horn chirps
three times. Press and hold
least three seconds to sound the
panic alarm. The horn sounds and
the turn signals flash until
pressed again or the key is placed
in the ignition and turned to
ON/RUN.
: If equipped, first press and
release then immediately press
and hold for at least
four seconds to start the engine
from outside the vehicle using the
RKE transmitter. See Remote
Vehicle Start 0 28.
The buttons on the keys are
disabled when there is a key in the
ignition.
Programming Transmitters to
the Vehicle
Only RKE transmitters programmed
to this vehicle will work. If a
transmitter is lost or stolen, a
replacement can be purchased and
programmed through your dealer.
When the replacement transmitter is
programmed to this vehicle, all
remaining transmitters must also be
for at
reprogrammed. Any lost or stolen
transmitters will no longer work
once the new transmitter is
programmed. Each vehicle can
is
have up to eight transmitters
programmed to it. See your dealer
to have new transmitters
programmed.
Keys, Doors, and Windows
Battery Replacement
Replace the battery if the REPLACE
BATTERY IN REMOTE KEY
message displays in the DIC. See
Key and Lock Messages 0 115.
Caution
When replacing the battery, do
not touch any of the circuitry on
the transmitter. Static from your
body could damage the
transmitter.
The battery is not rechargeable. To
replace the battery:
1. Press the button on the
transmitter to extend the key.
2. Remove the battery cover by
prying with a finger.
3. Remove the battery by pushing
on the battery and sliding it
toward the key blade.
4. Insert the new battery, positive
side facing up. Push the
battery down until it is held in
place. Replace with a CR2032
or equivalent battery.
27