Unpacking The Unit; Removing The Unit From The Pallet Using Piano Jacks - Emerson Liebert CRV User Manual

S When handling the packaged unit with a fork lift or pallet jack, the unit shall not be lifted any
higher than 51­102 mm off the ground. All by­standing personnel shall be no closer than 3.7
m to the handled packaged unit.
S If circumstances require the unit to be lifted higher than 102 mm great care shall be excercised
and all by­standing personnel are to be no closer than 5 m to the lift point of the unit.
3.4

Unpacking the Unit

1. Remove the exterior stretch wrap packaging
material from around the unit, exposing the pro­
tective corner and side packaging planks.
2. Remove the corner and side packaging planks
from the unit, exposing the bag over the unit.
The bag may remain in place for dust and panel
protection, or removed for immediate unit in­
stallation.
3. Remove the bag when ready to install the unit.
3.5

Removing the Unit from the Pallet using Piano Jacks

1.
S Remove sixteen (16) lag bolts that secure the
four (4) top deck boards, two (2) on each end
of the pallet. The lag bolts can be removed us­
ing a 1/2" socket wrench, open­end wrench, or
pliers.
S Remove the four (4) deck boards.
2.
S Open top panel door with the mounted con­
trol.
S Remove bottom baffle panel assembly by re­
moving screws using a standard screw driver.
S Set baffle panel assembly side in a safe loca­
tion until instructed to re­attach.
S Close and latch top panel door.
14
Unpacking and installation