Samsung WD106UHSA SERIES Service Manual page 41

error Type
error
mode
HE
HE1
heater error
HE2
HE3
LE
Water leakage
error
LE1
OE
Overflow Error
OF
drum
Fully
old
automatic
error For usA
mode
HE
E5
HE1
E1
Ec
Hr
-
(Heater
Relay)
HE2
-
11E
LE LE
E9
OE
OF OE -
E3
Causes
- The washing heater is short-circuited or has a
wire disconnected.
- The washing heater in the tub has an error.
(Contact error, temperature sensor fault)
- If the water level sensor operates without water
because water is frozen or for any other reason
and the temperature sensor engaged at the
bottom to prevent overheating for the washing
heater detects a temperature of 100 to 150 ˚C,
the washing machine turns the input power off.
- This error occurs when the red temperature
sensor at the center of the dry heater operates (at
a temperature higher than 145 ˚C)
: Corrective action – Press the button at the
center lightly. The washing machine will
operate normally.
Alternatively, replace the temperature sensor if
the temperature sensing is unstable because of
functional degradation.
- This occurs when the steam function does not
operate normally.
- This error does not occur in existing drum
products. Check whether the product is a steam
model
- Heater engagement fault (out of place)
- The air hose is out of place and water leakage
occurs during the spin cycle.
- The tub back at the safety bolts fixing part is
broken.
- Water leakage occurs at the front with foaming
because of too much detergent
- Water leakage occurs because the connecting
hose to the detergent drawer is connected
incorrectly.
- The drain pump filter cover is engaged incorrectly.
- Water leakage occurs at the drain hose.
- The duct condensing holding screws are worn.
- The nozzle-diaphragm is engaged in the opposite
direction or the rubber packaging is omitted.
- Water leakage occurs because the screws that
hold the tub back and front in place are fastened
incorrectly.
- The leakage sensor is faulty.
- Water is supplied continually because the water
level detection does not work.
- Because the drain hose is clogged and there
is an injection error (at a narrow section), the
water level detection does not work and water is
supplied continually.
- Water is supplied continually because of freezing
or because there is foreign material in the water
supply valve.
- This error may occur when the water level sensor
is degraded.
remarks
For USA
products, if
the heater
has no error,
this occurs
because of
a PBA relay
malfunction.
For USA
products, this
error occurs
because the
water level
sensor terminal
is out of place.
Troubleshooting _ 39